Plate reverb

Not Rated Yet

A plate reverb unit is constructed in the following way: Electrical signal carrying the sound is sent to a metal plate through a transducer similar to a speaker driver. The metal plate vibrates with the sound and then has residual "echo" vibrations. Another transducer – one similar to a guitar pickup – picks up the vibrations of the plate and converts them into an electric signal. Since this second transducer picks up also the residual "echo" vibrations of the plate the end result is a reverberated sound.

Plate reverb is reverb simulated by using an output transducer to pick up the residual vibrations of a metal plate after initial vibrations in the plate are generated by an input transducer.

A plate reverb unit works similarly to a spring reverb unit except that it uses a metal plate instead of springs.

The plate reverb exhibits specific qualities because of its construction. It has large diffusion and a specific coloration – it accentuates frequencies above 2 KHz creating a notable sibilance and shimmer.



  Rating
Rate This Page: Poor Great   |  Rate Content |
Average rating:  No Ratings Yet   
Number of Ratings : 0
  Comments
Add Comment
No Comments Yet


Copyright 2006 by Kaliopa Publishing, LLC